Description
Galvanized All-Thread Rod 1-1/8" Dia 7 TPI No Hardness Stamp Sold by the Foot
This is galvanized all-thread rod with a 1-1/8" (1.125") diameter and 7 threads per inch (TPI), sold by the foot from available cut sections. The rod carries no hardness stamp. It features a zinc galvanized coating for corrosion resistance and full continuous threading along the entire length. Available lengths are listed below; please note that quantities and available lengths can change — contact us before purchasing to confirm your needed length is in stock.
Specifications & What's Included
- Type: Galvanized All-Thread (Fully Threaded) Rod
- Diameter: 1-1/8" (1.125")
- Thread Pitch: 7 TPI (Threads Per Inch) — UNC (Unified National Coarse)
- Surface Finish: Zinc galvanized (corrosion-resistant coating)
- Hardness Stamp: None (no hardness grade marking)
- Sold by: the foot, in pre-cut sections
- Available lengths on hand: 36" (qty ~21) and 27" (qty ~25) — subject to change; contact us to verify
Applications
All-thread rod (also called threaded rod or fully threaded rod) is a standard fastener used across construction, mechanical, and industrial applications wherever a continuous length of threading is needed. At 1-1/8" diameter with a coarse 7 TPI thread, this is heavy-duty rod suited for structural anchoring, hanger rod systems, concrete anchor bolts, pipe support hangers, machinery mounting, and general fabrication work. The galvanized finish makes it well-suited for outdoor, wet, or corrosive environments where plain steel rod would be prone to rust. All-thread rod at this diameter is commonly used in commercial construction for suspended ceiling systems, structural connections, and heavy mechanical equipment supports. It accepts standard 1-1/8"-7 UNC hex nuts and couplings. The absence of a hardness stamp means the grade cannot be confirmed from the material itself — buyers with specific strength or grade requirements should verify suitability for their application before use.
This galvanized all-thread rod (1-1/8" diameter, 7 TPI) is used surplus stock that has been visually inspected and is in good physical condition. The zinc galvanized coating shows minor surface wear consistent with storage, and the threads appear clean and intact across the length. There is no hardness stamp on this material. Stock is sold by the foot in the available cut lengths listed; quantities and lengths on hand can change, so please contact us before purchasing to confirm that your needed length is in stock. Please view our photo set and contact us if you have any questions. Please note: We have multiple units in stock — yours may not be the one shown in the photos, however, it will be similar in condition and function.
Warranty Information
Additional Information
Brand: |
Unbranded |
Model: |
All-Thread Rod 1-1/8" 7 TPI Galvanized |
Type: |
Galvanized All-Thread Threaded Rod |
SKU: |
36996 |
Diameter: |
1-1/8" (1.125") |
Thread Pitch: |
7 TPI (Threads Per Inch) |
Thread Standard: |
UNC (Unified National Coarse) |
Surface Finish: |
Galvanized (Zinc Coated) |
Hardness Stamp: |
No Hardness Stamp |
Available Lengths: |
27", 36" (contact us to confirm availability) |
Sold As: |
By the Foot |
Material: |
Steel, Galvanized |
Condition: |
Used – Inspected and Pulled from Working Environment |
Seller Notes: |
Sold by the foot; contact us before purchase to confirm length and quantity availability. No hardness stamp. |
Condition Notes: |
Used galvanized all-thread rod, 1-1/8" dia, 7 TPI, no hardness stamp. Threads intact, minor surface wear. Sold by the foot — contact us before ordering to confirm available lengths and quantities. |
