Description
Semi-Rigid Coax Cable SMA-M to Right Angle SMA-M 7 Inch 0.141 RF Jumper
This is a semi-rigid coaxial cable assembly with a straight SMA male connector on one end and a right-angle (90°) SMA male connector on the other. The cable measures approximately 7 inches in length with a braided outer jacket and standard 50-ohm SMA terminations. It is a passive RF interconnect with no brand markings visible on the cable or connectors.
Specifications & What's Included
- Cable type: Semi-rigid / flexible braided coaxial
- Connector 1: SMA Male (straight)
- Connector 2: SMA Male (right angle / 90°)
- Approximate length: 7 inches
- Approximate outer diameter: 0.137 in (per seller measurement)
- Impedance: 50 Ohm (standard SMA)
- Connector hardware: Stainless steel coupling nuts with gold center pins
- Brand: Unbranded / no manufacturer markings visible
- Included: Cable assembly only — no additional accessories
Applications
Semi-rigid and flexible semi-rigid coaxial cable assemblies with SMA connectors are standard interconnects in RF and microwave test environments. They are commonly used to connect ports on spectrum analyzers, network analyzers, signal generators, power meters, and other bench test instruments where a short, low-loss RF jumper is needed. The right-angle SMA connector allows the cable to route cleanly in tight spaces or along panel edges without sharp bends in the cable body — a practical advantage when routing signals between adjacent instrument ports or within rack assemblies. SMA connectors (SubMiniature version A) are rated to 18 GHz or higher depending on construction, and have been a standard in microwave and RF instrumentation since the 1960s. Cables of this type are used in semiconductor test, aerospace/defense electronics, lab research, and general RF prototyping and repair.
This semi-rigid SMA-M to right-angle SMA-M coaxial cable has been inspected and is in good used condition. It was pulled from a working lab or test environment where it was previously in service. The braided outer jacket and both SMA connectors appear intact with no visible damage, kinks, or broken hardware. Normal light surface wear is present consistent with prior use. Please view our photo set and contact us if you have any questions. Please note: We have multiple units in stock — yours may not be the one shown in the photos, however, it will be similar in condition and function.
Warranty Information
Additional Information
Brand: |
Unbranded |
Model: |
Semi-Rigid SMA-M to Right Angle SMA-M RF Cable |
Type: |
Semi-Rigid Coaxial Cable Assembly |
Connector 1: |
SMA Male (Straight) |
Connector 2: |
SMA Male (Right Angle / 90°) |
Cable Length: |
Approx. 7 inches |
Cable Outer Diameter: |
Approx. 0.137 in (per seller measurement) |
Cable Construction: |
Semi-Rigid / Flexible Braided Coaxial |
Application: |
RF, Microwave, Test Equipment Interconnect |
Gender: |
Male to Male |
Impedance: |
50 Ohm (standard SMA) |
SKU: |
29988 |
Condition: |
Used – Pulled from Working Environment |
Seller Notes: |
Cable only. No additional accessories included. |
Compatible With: |
RF test equipment, spectrum analyzers, signal generators |
Compatible With 2: |
Network analyzers, lab bench instruments with SMA ports |
Condition Notes: |
Semi-rigid SMA-M to right-angle SMA-M RF cable. Inspected and in good used condition. Pulled from a working lab environment. Connectors and jacket appear intact with no damage. Approx. 7 inches long. |
