RF Cable 200087-003 REV-5 9 Inch SMA Male to Gold Pin Coaxial Jumper AS-IS

RF Cable 200087-003 REV-5 9 Inch SMA Male to Gold Pin Coaxial Jumper AS-IS

This is a 9-inch semi-rigid braided coaxial RF cable assembly, part number 200087-003 REV-5. One end terminates in a stainless steel SMA male connector; the other ends in a gold anodized hex-body connector with a white PTFE center pin insulator and orange O-ring seal. The part number and revision are printed on a label sleeve bonded to the cable body. This item is being sold AS-IS for parts or repair — electrical performance has not been tested or verified.

Specifications & What's Included

• Part Number: 200087-003
• Revision: REV-5
• Cable length: approximately 9 inches (229 mm)
• Cable construction: semi-rigid coaxial with silver braided outer shield
• Connector 1: SMA male (stainless steel hex body, center pin with purple dielectric)
• Connector 2: Gold anodized aluminum hex-body RF connector with white PTFE insulator and orange O-ring
• Part number / revision label sleeve bonded to cable body
• Sold AS-IS — no accessories or documentation included

Applications

Short semi-rigid coaxial jumper cables of this type are used as internal RF interconnects inside test equipment, RF transceivers, wireless base stations, radar systems, and other microwave or RF assemblies. The SMA interface is one of the most common coaxial connector standards across RF and microwave applications from roughly 500 MHz through 18 GHz and beyond, and is found across commercial, defense, and laboratory equipment. The gold-body panel-mount style connector on the opposite end is typical of internal chassis feed-throughs used to route RF signals between an internal assembly and an external panel. Cables like this are sought for equipment repair, prototyping, and replacement of damaged internal RF leads in existing assemblies. Manufacturer is not identified from markings; buyers should verify connector gender, pin diameter, and thread pitch against their application before ordering.