Description
Pamtech ULG1005 RF Dummy Load 50W N-Female Coaxial Termination Lab Resistor
The Pamtech ULG1005 is a coaxial RF dummy load designed to terminate RF signal lines and absorb power without radiating it. Built into a compact finned aluminum heatsink body, it dissipates RF power as heat and is rated for approximately 50W of power handling. The N-female connector provides a standard, secure interface for coaxial connections common in RF test and measurement work.
Specifications & What's Included
- Manufacturer: Pamtech (Canoga Park, CA)
- Model: ULG1005
- Type: RF Dummy Load / Coaxial Termination Resistor
- Connector: N-Female
- Impedance: 50 Ohm (standard coaxial)
- Estimated Power Handling: ~50W
- Body: Finned aluminum heatsink — passive air cooling
- Note: A "DO NOT USE UNTIL CALIBRATED" sticker is present on the unit
- Includes: RF load unit only — no cables or accessories
Applications
RF dummy loads like the ULG1005 are standard tools in RF and microwave lab environments. They are used to terminate transmission lines, provide a matched load for transmitter testing, and protect sensitive equipment during signal path troubleshooting — situations where a real antenna or circuit cannot or should not be connected. The N-female interface makes this load compatible with a wide range of RF test equipment, signal generators, amplifiers, and transmitters operating at standard 50-ohm impedance. Units of this type are commonly used in telecommunications, radar, satellite ground station testing, and general RF bench work. The calibration sticker on this unit indicates it was previously used in a calibrated or metrology environment — buyers should plan to verify calibration before precision use.
This Pamtech ULG1005 RF Dummy Load has been inspected and appears to be in good used condition. The finned aluminum heatsink body shows typical handling wear. A yellow 'DO NOT USE UNTIL CALIBRATED' sticker is present on the unit — buyers should be aware that calibration verification is recommended before putting this load into service. The N-female connector appears clean and undamaged. Please view our photo set and contact us if you have any questions.
Warranty Information
Additional Information
Brand: |
Pamtech |
Model: |
ULG1005 |
MPN: |
ULG1005 |
Type: |
RF Dummy Load / Coaxial Termination Resistor |
SKU: |
24870 |
Connector Type: |
N-Female |
Impedance: |
50 Ohm |
Power Handling: |
~50W (estimated) |
Body / Heatsink: |
Finned Aluminum Heatsink |
Manufacturer Location: |
Canoga Park, CA |
Application: |
RF Signal Termination, Microwave Test, Lab |
Seller Notes: |
RF load only — no cables or additional accessories included. |
Condition Notes: |
This Pamtech ULG1005 RF Dummy Load has been inspected and is in good used condition. Heatsink shows typical wear. A 'DO NOT USE UNTIL CALIBRATED' sticker is present — calibration verification recommended before use. N-female connector appears clean. |
California Prop 65 Warning: |
WARNING: This product can expose you to chemicals including lead and lead compounds, and DEHP (a phthalate), which are known to the State of California to cause cancer and birth defects or other reproductive harm. Go to P65Warnings.ca.gov |
