Bessel

Bessel Low Pass Filter 4.5 MHz 5-Pole 50 Ohm BNC In/Out RF Signal

(No reviews yet) Write a Review
SKU:
32934
Condition:
Used
Availability:
Currently out of stock — contact us for availability.
Weight:
3.00 LBS
Shipping:
Calculated at Checkout
  • Bessel 4.5 MHz 5-pole low pass filter — three-quarter front/side view showing teal metal housing with label on top and BNC output connector on right end
  • Bessel 4.5 MHz low pass filter — close-up of BNC female IN port on input end panel with panel-mount flange and mounting holes
  • Bessel 4.5 MHz low pass filter — close-up of BNC female OUT port on output end panel labeled OUT with mounting flange
  • Bessel 4.5 MHz low pass filter — top label reading '4.5 MHZ BESSEL FILTER 5 POLE, IN OUT, 50 OHM IN/OUT, LOW PASS'
$35.00

This item is temporarily unavailable. Please view our recommended, in-stock alternatives directly below.

Description

Bessel Low Pass Filter 4.5 MHz 5-Pole 50 Ohm BNC In/Out RF Signal

This is a passive 5-pole Bessel low pass filter with a 4.5 MHz cutoff frequency and 50 ohm input/output impedance. It is housed in a compact shielded metal enclosure with panel-mount BNC female connectors on each end, labeled IN and OUT. The Bessel topology is chosen for its maximally flat group delay (linear phase response), which minimizes signal distortion and ringing on the filtered waveform — a key advantage over Butterworth or Chebyshev designs when waveform fidelity matters more than sharp rolloff.

Specifications & What's Included

  • Filter type: Bessel (maximally flat group delay / linear phase)
  • Response: Low Pass
  • Cutoff frequency: 4.5 MHz
  • Number of poles: 5
  • Impedance: 50 ohm (in and out)
  • Input connector: BNC female (panel mount)
  • Output connector: BNC female (panel mount)
  • Enclosure: Shielded aluminum housing, teal/blue anodized finish
  • Mounting: Integral chassis flanges with mounting holes on each end
  • Label reads:
    Condition: Used
    This Bessel 4.5 MHz 5-pole low pass filter has been inspected and appears to be in good used condition. The metal housing shows minor surface wear consistent with prior use, but the chassis is intact and the BNC connectors on both the input and output ends are clean and undamaged. It has not been powered up or tested at our facility, but was pulled from a working environment where it was previously in use. Please view our photo set and contact us if you have any questions.
View AllClose

Warranty Information

We stand behind every item we sell with a 30-day money-back guarantee. If your item arrives not as described, you may return it within 30 days for a full refund. Please inspect your purchase upon arrival and contact us with any questions.
View AllClose

Additional Information

Brand:
Unbranded
Model:
4.5 MHz Bessel Filter 5 Pole
Type:
Bessel Low Pass Filter
Filter Type:
Bessel
Response Type:
Low Pass
Cutoff Frequency:
4.5 MHz
Number of Poles:
5
Impedance:
50 Ohm
Connector Type:
BNC (Female)
Input Connector:
BNC Female
Output Connector:
BNC Female
Enclosure:
Shielded metal housing, teal/blue anodized aluminum
Mounting:
Panel/chassis mount flanges
Form Factor:
Enclosed Module
SKU:
32934
Seller Notes:
Filter module only — no cables or adapters included.
Condition Notes:
This Bessel 4.5 MHz 5-pole low pass filter is in good used condition. Housing shows minor wear; BNC connectors are clean and undamaged. Not tested at our facility but pulled from a working environment.
California Prop 65 Warning:
WARNING: This product can expose you to chemicals including lead and lead compounds, and DEHP (a phthalate), which are known to the State of California to cause cancer and birth defects or other reproductive harm. Go to P65Warnings.ca.gov
View AllClose